USB 2.0 Internal 6-in-1 Card Reader User’s Manual P/N TS0MFLRD6E
8 To Use with Linux Kernel 2.4 or Later The Internal 6-in-1 Card Reader is a driver-free device for Linux kernel 2.4 or later. Just follow the proced
9Boot-up Function The CompactFlash slot of the Internal 6-in-1 Card Reader can be configured as a bootable drive. To enable the Boot-Up function, you
10To Boot-up with AMI BIOS 1. Power on your system and follow the on-screen instructions to enter BIOS or the CMOS setup utility. 2. Refer to the o
116. Select Boot Device Select. 7. Select USB RMD-FDD Generic STORAGE DEVICE for the 1st Boot Device, then press ESC. 8. Choose Save & Exit Set
12Specifications Power supply... DC 5V from USB port Slots for storage media: ...
Card Reader Limited Warranty “Above and beyond” is the standard we set ourselves for customer service at Transcend. We consistently position ourselve
Table of Contents Introduction Package Contents...
1Introduction Thank you for purchasing Transcend’s Internal 6-in-1 Card Reader, a small device de-signed for fast, easy data exchange using six types
2Driver Installation Driver Installation for Windows 98SE, Me, and 2000 1. Power on the computer where you will install the Internal 6-in-1 Card Rea
34. The InstallShield Wizard appears. Click Next. 5. Click Finish to complete the driver installation. If using Windows 98SE or Me, the syste
4Driver Installation for Windows XP, Linux Kernel 2.4 or Later No driver is needed. Turn off the computer and refer to Hardware Setup below to instal
5RedWhiteGreenBlackThick Black 12345109876 5. If the layout of USB pin-header does not match the default setting of USB connector (shown above), r
6b. Refer to the pin assignment of USB connector (as below) and to realign the color wires. c. Keep the same side of wire pins facing up and inse
7 2. Four Removable Disk drives with newly assigned drive letters appear in My Com-puter. The Internal 6-in-1 Card Reader is ready for use. To Use w
Commentaires sur ces manuels